A3822-25 Spinal 25g Whitacre

A3822-25 Spinal 25g Whitacre Manufacturers

• Smiths Medical Asd, Inc.
  

  ×

  A3822-25 Spinal 25g Whitacre | Smiths Medical Asd, Inc.

  

  ---

  Dosage and Administration

  Subcutaneously or intramuscularly – 0.2 to 1 mL (mg). Start with a small dose and increase if required.
  Note: The subcutaneous is the preferred route of administration. If given intramuscularly, injection into the buttocks should be avoided.

  Hypersensitivity Reactions
  For bronchial asthma and certain allergic manifestations, e.g., angioedema, urticaria, serum sickness, anaphylactic shock, use epinephrine subcutaneously. The adult intravenous dose for
  hypersensitivity reactions or to relieve bronchospasm usually ranges from 0.1 to 0.25 mg injected slowly. Neonates may be given a dose of 0.01 mg per kg of body weight; for the infant 0.05 mg is an adequate initial dose and this may be repeated at 20 to 30 minute intervals in the management of asthma attacks.
  Cardiac Resuscitation
  A dose of 0.5 mL (0.5 mg) diluted to 10 mL with sodium chloride injection can be administered intravenously or intracardially to restore myocardial contractility. Intracardiac injection should only be administered by personnel well trained in the technique, if there has not been sufficient time to establish an intravenous route. External cardiac massage should follow intracardial administration to permit the drug to enter coronary circulation. The drug should be used secondarily to unsuccessful attempts with physical or electromechanical methods.
  Ophthalmologic Use
  Ophthalmologic use (for producing conjunctival decongestion, to control hemorrhage, produce mydriasis and reduce intraocular pressure) – use a concentration of 1:10,000 (0.1 mg/mL) to
  1:1000 (1 mg/mL).
  Regional Anesthesia
  A final concentration of 1:200,000 of epinephrine injection is recommended for infiltration injection, nerve block, caudal or other epidural blocks. From 0.3 to 0.4 mg of epinephrine (0.3 to
  0.4 mL of 1:1000 solution) may be mixed with spinal anesthetic agents. Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration. (See PRECAUTIONS.)

  DOSAGE AND ADMINISTRATION

  Table 1 (Recommended Dosages) summarizes the recommended volumes and concentrations of Lidocaine Hydrochloride Injection, USP for various types of anesthetic procedures. The dosages suggested in this table are for normal healthy adults and refer to the use of epinephrine-free solutions. When larger volumes are required only solutions containing epinephrine should be used, except in those cases where vasopressor drugs may be contraindicated.

  There have been adverse event reports of chondrolysis in patients receiving intra-articular infusions of local anesthetics following arthroscopic and other surgical procedures.  Lidocaine is not approved for this use (see WARNINGS and DOSAGE AND ADMINISTRATION).

  These recommended doses serve only as a guide to the amount of anesthetic required for most routine procedures. The actual volumes and concentrations to be used depend on a number of factors such as type and extent of surgical procedure, depth of anesthesia and degree of muscular relaxation required, duration of anesthesia required, and the physical condition of the patient. In all cases the lowest concentration and smallest dose that will produce the desired result should be given. Dosages should be reduced for children and for elderly and debilitated patients and patients with cardiac and/or liver disease.

  The onset of anesthesia, the duration of anesthesia and the degree of muscular relaxation are proportional to the volume and concentration (i.e., total dose) of local anesthetic used. Thus, an increase in volume and concentration of Lidocaine Hydrochloride Injection will decrease the onset of anesthesia, prolong the duration of anesthesia, provide a greater degree of muscular relaxation and increase the segmental spread of anesthesia. However, increasing the volume and concentration of Lidocaine Hydrochloride Injection may result in a more profound fall in blood pressure when used in epidural anesthesia. Although the incidence of side effects with lidocaine is quite low, caution should be exercised when employing large volumes and concentrations, since the incidence of side effects is directly proportional to the total dose of local anesthetic agent injected.

  For intravenous regional anesthesia, only the 50 mL single-dose vial containing 0.5% Lidocaine Hydrochloride Injection, USP should be used.

  Epidural Anesthesia

  For epidural anesthesia, only the following available specific products of Lidocaine Hydrochloride Injection by Hospira are recommended:

  1%. . . . . . . . . . . . . . . . . . . . 30 mL single-dose teartop vials

  1.5%. . . . . . . . . . . . . . . . . . . . . . . 20 mL single-dose ampuls

  2%. . . . . . . . . . . . . . . . . . . . . . . . . 10 mL single-dose ampuls

  Although these solutions are intended specifically for epidural anesthesia, they may also be used for infiltration and peripheral nerve block provided they are employed as single dose units. These solutions contain no bacteriostatic agent. In epidural anesthesia, the dosage varies with the number of dermatomes to be anesthetized (generally 2−3 mL of the indicated concentration per dermatome).

  Caudal and Lumbar Epidural Block: As a precaution against the adverse experiences sometimes observed following unintentional penetration of the subarachnoid space, a test dose such as 2−3 mL of 1.5% lidocaine hydrochloride should be administered at least 5 minutes prior to injecting the total volume required for a lumbar or caudal epidural block. The test dose should be repeated if the patient is moved in a manner that may have displaced the catheter. Epinephrine, if contained in the test dose (10−15 mcg have been suggested), may serve as a warning of unintentional intravascular injection. If injected into a blood vessel, this amount of epinephrine is likely to produce a transient "epinephrine response" within 45 seconds, consisting of an increase in heart rate and systolic blood pressure, circumoral pallor, palpitations and nervousness in the unsedated patient. The sedated patient may exhibit only a pulse rate increase of 20 or more beats per minute for 15 or more seconds. Patients on beta-blockers may not manifest changes in heart rate, but blood pressure monitoring can detect an evanescent rise in systolic blood pressure. Adequate time should be allowed for onset of anesthesia after administration of each test dose. The rapid injection of a large volume of Lidocaine Hydrochloride Injection through the catheter should be avoided, and, when feasible, fractional doses should be administered.

  In the event of the known injection of a large volume of local anesthetic solutions into the subarachnoid space, after suitable resuscitation and if the catheter is in place, consider attempting the recovery of drug by draining a moderate amount of cerebrospinal fluid (such as 10 mL) through the epidural catheter.

  Maximum Recommended Dosages

  NOTE: The products accompanying this insert do not contain epinephrine.

  Adults: For normal healthy adults, the individual maximum recommended dose of lidocaine HCl with epinephrine should not exceed 7 mg/kg (3.5 mg/lb) of body weight and in general it is recommended that the maximum total dose not exceed 500 mg. When used without epinephrine, the maximum individual dose should not exceed 4.5 mg/kg (2 mg/lb) of body weight and in general it is recommended that the maximum total dose does not exceed 300 mg. For continuous epidural or caudal anesthesia, the maximum recommended dosage should not be administered at intervals of less than 90 minutes. When continuous lumbar or caudal epidural anesthesia is used for non-obstetrical procedures, more drug may be administered if required to produce adequate anesthesia.

  The maximum recommended dose per 90 minute period of lidocaine hydrochloride for paracervical block in obstetrical patients and non-obstetrical patients is 200 mg total. One-half of the total dose is usually administered to each side. Inject slowly five minutes between sides. (See also discussion of paracervical block in PRECAUTIONS).

  For intravenous regional anesthesia, the dose administered should not exceed 4 mg/kg in adults.

  Children: It is difficult to recommend a maximum dose of any drug for children, since this varies as a function of age and weight. For children over 3 years of age who have a normal lean body mass and normal body development, the maximum dose is determined by the child’s age and weight. For example, in a child of 5 years weighing 50 lbs., the dose of lidocaine HCl should not exceed 75 — 100 mg (1.5 — 2 mg/lb). The use of even more dilute solutions (i.e., 0.25 — 0.5%) and total dosages not to exceed 3 mg/kg (1.4 mg/lb) are recommended for induction of intravenous regional anesthesia in children.

  In order to guard against systemic toxicity, the lowest effective concentration and lowest effective dose should be used at all times. In some cases it will be necessary to dilute available concentrations with 0.9% sodium chloride injection in order to obtain the required final concentration.

  Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration whenever the solution and container permit. Solutions that are discolored and/or contain particulate matter should not be used.

  Table 1

  Recommended Dosages of Lidocaine Hydrochloride Injection, USP for Various Anesthetic

  Procedures in Normal Healthy Adults

  
  
  
  

  Lidocaine Hydrochloride Injection, USP (without Epinephrine)

  
  
  
  
  

  Procedure

  Conc. (%)

  Vol. (mL)

  Total Dose (mg)

  
  
  
  
  

  Infiltration

  
  
  
  

  Percutaneous

  0.5 or 1.0

  1−60

  5−300

  Intravenous Regional

  0.5

  10−60

  50−300

  
  
  
  
  

  Peripheral Nerve Blocks, e.g.

  
  
  
  

  Brachial

  1.5

  15−20

  225−300

  Dental

  2.0

  1−5

  20−100

  Intercostal

  1.0

  3

  30

  Paravertebral

  1.0

  3−5

  30−50

  Pudendal (each side)

  1.0

  10

  100

  Paracervical

  
  
  
  

  Obstetrical Analgesia

  
  
  
  

  (each side)

  1.0

  10

  100

  
  
  
  
  

  Sympathetic Nerve Blocks, e.g.

  
  
  
  

  Cervical (stellate ganglion)

  1.0

  5

  50

  Lumbar

  1.0

  5−10

  50−100

  
  
  
  
  

  Central Neural Blocks

  
  
  
  

  Epidural*

  
  
  
  

  Thoracic

  1.0

  20−30

  200−300

  Lumbar

  
  
  
  

  Analgesia

  1.0

  25−30

  250−300

  Anesthesia

  1.5

  15−20

  225−300

  
  

  2.0

  10−15

  200−300

  Caudal

  
  
  
  

  Obstetrical Analgesia

  1.0

  20−30

  200−300

  Surgical Anesthesia

  1.5

  15−20

  225−300

  
  
  
  
  
  

  *Dose determined by number of dermatomes to be anesthetized (2 to 3 mL/dermatome).

  THE ABOVE SUGGESTED CONCENTRATIONS AND VOLUMES SERVE ONLY AS A GUIDE. OTHER VOLUMES AND CONCENTRATIONS MAY BE USED PROVIDED THE TOTAL MAXIMUM RECOMMENDED DOSE IS NOT EXCEEDED.

  Sterilization, Storage and Technical Procedures: Disinfecting agents containing heavy metals, which cause release of respective ions (mercury, zinc, copper, etc.) should not be used for skin or mucous membrane disinfection as they have been related to incidence of swelling and edema. When chemical disinfection of multi-dose vials is desired, either isopropyl alcohol (91%) or 70% ethyl alcohol is recommended. Many commercially available brands of rubbing alcohol, as well as solutions of ethyl alcohol not of USP grade, contain denaturants which are injurious to rubber and, therefore, are not to be used. It is recommended that chemical disinfection be accomplished by wiping the vial stopper thoroughly with cotton or gauze that has been moistened with the recommended alcohol just prior to use.

  DOSAGE AND ADMINISTRATION

  The dose of any local anesthetic administered varies with the anesthetic procedure, the area to be anesthetized, the vascularity of the tissues, the number of neuronal segments to be blocked, the depth of anesthesia and degree of muscle relaxation required, the duration of anesthesia desired, individual tolerance, and the physical condition of the patient. The smallest dose and concentration required to produce the desired result should be administered. Dosages of MARCAINE Spinal should be reduced for elderly and debilitated patients and patients with cardiac and/or liver disease.

  For specific techniques and procedures, refer to standard textbooks.

  There have been adverse event reports of chondrolysis in patients receiving intra-articular infusions of local anesthetics following arthroscopic and other surgical procedures. MARCAINE Spinal is not approved for this use (see WARNINGS and DOSAGE AND ADMINISTRATION).

  The extent and degree of spinal anesthesia depend upon several factors including dosage, specific gravity of the anesthetic solution, volume of solution used, force of injection, level of puncture, and position of the patient during and immediately after injection.

  Seven and one-half mg (7.5 mg or 1 mL) MARCAINE Spinal has generally proven satisfactory for spinal anesthesia for lower extremity and perineal procedures including TURP and vaginal hysterectomy. Twelve mg (12 mg or 1.6 mL) has been used for lower abdominal procedures such as abdominal hysterectomy, tubal ligation, and appendectomy. These doses are recommended as a guide for use in the average adult and may be reduced for the elderly or debilitated patients. Because experience with MARCAINE Spinal is limited in patients below the age of 18 years, dosage recommendations in this age group cannot be made.

  Obstetrical Use: Doses as low as 6 mg bupivacaine hydrochloride have been used for vaginal delivery under spinal anesthesia. The dose range of 7.5 mg to 10.5 mg (1 mL to 1.4 mL) bupivacaine hydrochloride has been used for Cesarean section under spinal anesthesia.

  In recommended doses, MARCAINE Spinal produces complete motor and sensory block.

  Unused portions of solutions should be discarded following initial use.

  MARCAINE Spinal should be inspected visually for discoloration and particulate matter prior to administration; solutions which are discolored or which contain particulate matter should not be administered.

  Close
  No Recall

  More Info